Before activating the valet parking mode, a PIN must be set up to be able to deactivate the valet parking mode at a future time. The procedure for entering the PIN varies depending on the active driver profile:
Driver profile with PIN: A PIN has been stored for the active driver profile. It is not necessary to enter another PIN. “Activate now”
Driver profile without PIN:
-
- A PIN must be assigned to the driver profile. Steps> 1. “PIN” 2. Enter PIN. 3. “Activate now”
- Guest profile The guest profile is the active driver profile: A PIN must be entered. 1. “PIN” 2. Enter PIN. 3. “Activate now” This PIN can be used once to deactivate the valet parking mode for the active guest profile.
Perform the following steps to activate Valet Parking Mode:
Via the vehicle settings
1. "CAR"
2. "Settings"
3. "General settings"
4. "Valet parking mode"
Via the switch off screen:
After switching off drive-ready state the switchoff screen will be displayed. Select the entry for the valet parking mode on the switch-off screen.
Via the display bar at the upper edge of the Control Display
1. Tip the Controller up.
2. "Valet parking mode"
